It's easy to set your system, using either a pre-programmed tag or PIN code. (Conditons apply for PIN capability)

If you're at your property:

• Make sure all doors and windows that are alarmed are closed.
• Present a valid tag to the 'tag' icon on your keypad or enter your PIN.
• You can choose to set all or any "part set" area you have programmed. Area A is default, so press "Yes" to select this. If you wish to set another area select that (B, C, or D) and press 'Yes'.
• Wait for the message on the keypad to display "Please leave via Exit Route" and then leave the property via the "Final door". The exit sound will be continuous. 
• The exit tone will stop. After a few seconds this is then followed by a double bleep, confirming the alarm has successfully set.
• Some of your part sets may be set up as a "Timed Exit". This means you will need to leave that area before the timer shown on the keypad expires. Again this will then be followed by a double bleep confirming the alarm has successfully set.

Setting your alarm using a wireless arming station: 

• Make sure all doors and windows that are alarmed are closed. 
• The arming station is in 'sleep' mode to conserve battery life, and does not have an LCD display. Prese the X button to wake it up. 
• Present a valid tag to the 'tag' icon on your arming station, or enter your PIN
• You can choose to set all or any 'part set' area you have programmed. Area A is default, press A to select this and then press the 'tick' button. If you wish to set another area select that (B, C or D) and then press the 'tick' button. 
• Wait for the sound to be continuous and then leave the property through the 'final door'.
• The exit tone will stop. After a few seconds this is then followed by a double bleep, confirming the alarm has successfully set. 
• If you are setting a part-set, and staying in the property (for example a 'night set'), then this will normally count down silently for 30 seconds, and will be followed by the double bleep, confirming the alarm has been successfully set. 

If you're not at your property:
You can easily set your alarm through your SmartAlarm+2 app -

• Tap your security system
• Tap the open green padlock to start setting the alarm
• Note: all areas that show an open padlock are unset
• Once the system has set the chosen area, you will be disconnected on the APP while the alarm transmits it's signals.

You will receive a push notification to confirm that your system is set.